Skip to main content

Specification Data Sheet

Features

  • Horizontal bar joined at its centre by a vertical support bar with a shower head holder and fixing roses made of steel
  • With sideways adjustable vertical support bar
  • Shower head holder adjustable to required angle and height
  • With corrosion resistant steel core
  • For wall mounting with special fixing kit and roses from HEWI
  • Vertical length 1100 mm, horizontal length 962 mm
  • 90 mm deep, ø 33 mm, roses ø 70 mm
  • Suitable for hanging seat
  • Made of high-quality polyamide (please advise colour)

Note during installation: intervals between supports may not exceed 850 mm

Supplied BM211 with fixing material

A rear lining is required for installation with rose fixings on lightweight walls, e.g. laminated timber boards > 20 mm thick.

Environmental Sustainability

We are ISO 14001 certified and take sustainability seriously. Our products are environmentally responsible designed to be healthier for users, save water and/or energy, and minimise carbon footprint. Our target is to reduce our carbon footprint by 25%, and the use of non-recyclable/non-compostable materials across the company (e.g. plastics) by 50%.

Warranty

Galvin Engineering products are covered under our Manufacturer's Warranty. Galvin Engineering products must be installed in accordance with the installation instructions and in accordance with AS 3500 and NCC Volume Three, relevant Australian Standards and local authorities applicable to product being installed. Water and electrical supply conditions must also comply to the applicable national and/or state standards, failing to comply with these provisions may void the product warranty and affect performance of the product.

Please visit www.galvinengineering.com.au to view the full warranty, our Installation Compliance and Maintenance & Cleaning information as well as any other additional information.

While all reasonable care has been taken in compiling the information in this document, the designs, dimensions and products shown are indicative only and should not be relied upon without our prior approval. Due to our policy of continuous development, we reserve the right to alter any details of specifications or products without notice. All information, drawings, technical specifications and product designs remain the property of Galvin Engineering Pty Ltd.