Skip to main content


Specification Data Sheet

Our Galvin CliniMix® range of thermostatic mixing valves (TMVs) is designed to protect the most vulnerable from scalding or cold water shock by providing tempered water to the desired outlets that comply with the relevant Australian Standards. 

  • Manufactured using Lead Safe™ DZR Brass with less than 0.25% lead content*
  • Safe, simple and easy to maintain.
  • Flat-faced connections allow removal of the valve without disturbing the pipework.
  • In the event of either hot or cold water supply failure the valve will shut down, quickly restoring flow when normal conditions resume.
  • Suitable for installation in low-pressure systems and will operate with working pressure as low as 20kPA.
  • Water temperature is established at plus or minus 2 degrees even during water pressure or temperature fluctuations. 
  • Units come complete with right angles isolating ball valve, non-return valve and strainer assemblies. 
  • Can be installed in any configuration with the water outlet in the horizontal or vertical position, and inlet connections can be rotated to suit inlet pipework.
Technical Information
  • WaterMark: AS 4032.1 Lic. WMKA21989
  • Inlet: 1/2" BSP - Male
  • Outlet: 1/2" or 3/4 BSP
  • Headwork: Thermostatic Mixing Valve (TMV)
  • Working Pressure Range (kPa): 20 Min - 500 Max 
  • Hot Supply Temperature Range (°C): 55 Min - 90 Max
  • Cold Supply Temperature Range (°C): 5 Min - 30 Max
  • Adjustable Temperature Range (°C): 35 Min - 48 Max 
  • Maximum Inlet pressure Ratio: 6:1 
  • Factory Set Thermostatic Temperature (°C): 43.5 
  • Minimum Flow Rate for stable outlet temperature (LPM): 6 
  • Maximum Flow Rate (LPM): 25 lpm @100kPa
  • Construction: Lead Safe™ DZR Brass*
  • Finish: Brass

Spare Parts

  • WM-ATC-2 Anti-Tamper Cap for CliniMix® (Green)

Superseding Products

  • WM-TMV1 CliniMix® Thermostatic Mixing Valve with 15 Inlet & 15/20 Outlet

Environmental Sustainability

We are ISO 14001 certified and take sustainability seriously. Our products are environmentally responsible designed to be healthier for users, save water and/or energy, and minimise carbon footprint. Our target is to reduce our carbon footprint by 25%, and the use of non-recyclable/non-compostable materials across the company (e.g. plastics) by 50%.


Galvin Engineering products are covered under our Manufacturer's Warranty. Galvin Engineering products must be installed in accordance with the installation instructions and in accordance with AS 3500 and NCC Volume Three, relevant Australian Standards and local authorities applicable to product being installed. Water and electrical supply conditions must also comply to the applicable national and/or state standards, failing to comply with these provisions may void the product warranty and affect performance of the product.

Please visit to view the full warranty, our Installation Compliance and Maintenance & Cleaning information as well as any other additional information.

While all reasonable care has been taken in compiling the information in this document, the designs, dimensions and products shown are indicative only and should not be relied upon without our prior approval. Due to our policy of continuous development, we reserve the right to alter any details of specifications or products without notice. All information, drawings, technical specifications and product designs remain the property of Galvin Engineering Pty Ltd.

Our Lead Safe™ product range is compliant with the Lead Free Requirements of the NCC 2022 Vol. Three, Clause A5G4(2) and NSF/ANSI 372.