The HeelGrate® SS316 Floor Drain Grate Square Assembly 100x80 BSP is a complete stainless steel floor drain assembly for commercial and public-space installations where a BSP threaded connection to the waste pipework is required.
The grade 316 stainless steel grate assembly combines the 5mm bar gap heel-safe geometry of the HeelGrate® range with a stainless steel body and BSP threaded outlet, providing a single-component solution ready for direct specification and installation. Complies with AS 3996 to Class B. WaterMark certified to WMTS 040 (Lic. WMK02448).
Features
• 5mm bar gap - heel-safe, crutch-tip-safe, wheelchair-wheel-safe
• Stainless steel grate and body
• Precision-machined grate surface
• Stainless steel lockdown Allen key screws
• BSP threaded outlet for direct connection to waste pipework
• Complies with AS 3996 to Class B
• Suitable for concourse paving, tiled and concrete-finished floors
Flow Rate Guide - Litres per Minute at Varying Pressure Head (mm of Water)
| Pressure Head mm of Water | ||||
| 10mm | 20mm | 30mm | 40mm | 50mm |
| 56.6 | 84.3 | 103.3 | 116 | 125.1 |
Technical Information
We are ISO 14001 certified and take sustainability seriously. Our products are environmentally responsible designed to be healthier for users, save water and/or energy, and minimise carbon footprint. Our target is to reduce our carbon footprint by 25%, and the use of non-recyclable/non-compostable materials across the company (e.g. plastics) by 50%.
Galvin Engineering products are covered under our Manufacturer's Warranty. Galvin Engineering products must be installed in accordance with the installation instructions and in accordance with AS 3500 and NCC Volume Three, relevant Australian Standards and local authorities applicable to product being installed. Water and electrical supply conditions must also comply to the applicable national and/or state standards, failing to comply with these provisions may void the product warranty and affect performance of the product.
Please visit www.galvinengineering.com.au to view the full warranty, our Installation Compliance and Maintenance & Cleaning information as well as any other additional information.
While all reasonable care has been taken in compiling the information in this document, the designs, dimensions and products shown are indicative only and should not be relied upon without our prior approval. Due to our policy of continuous development, we reserve the right to alter any details of specifications or products without notice. All information, drawings, technical specifications and product designs remain the property of Galvin Engineering Pty Ltd.
Click the buttons below to read Galvin Engineering's Terms and Conditions.
 |
 |
 |
